Casablanca Fan Co. • Factory Service Department • Technical Library
The fan may be turned ON and OFF by the W-28 wall control.
The lights may be turned ON and OFF by the W-28 and the intensity adjusted from low to high.
The fan must be supplied with two independent 120V AC supply wires.
Set the FAN pull chain switch to the HIGH speed setting.
Turn the lights ON at the fan.
The W-28 allows the choice of four (3) different speed settings.
CAUTION!
Failure to set the pullchain speed to HIGH can result in faulty
operation of the fan and damage to the W-28 wall control. To confirm fan is
set to HIGH: Turn W-28 fan speed switch to ‘HI’ - set fastest fan speed with pull
chain.
IMPORTANT NOTE: The fan
must be supplied with three
independent 120V AC supply
wires to provide power for the
fan, the light, and neutral.
Installation is to be in
accordance with all
National Electrical Code
and local codes
WARING:
DONOT use this wiring diagram
when wiring W-8 or W-80 wall controls. This
will cause damage to both the PC Board and
Wall Control