Casablanca Silhouette II, Owner'S Manual

Page: 7 / 16

7
S
ILHOUETTE
II
™
LIGHT FIXTURE INSTALLATION
Step 7a. Insert three switch housing screws (Pack F) into
the screwholes in the center of the motor.
Step 7b. Hold the switch housing up to the motor. Feed
the wires through the center hole and align the switch
housing screws (F) with the keyholes. Twist the switch
housing clockwise.
Step 7c. Tighten all three screws using the screwdriver.
Step 7d. Remove the ceramic wire nuts from the wires on
the socket plate and set aside for use in the next two steps.
Step 7e. Attach the WHITE wire on the socket plate to
the WHITE wire on the switch housing. Secure with a
ceramic wire nut.
Step 7f. Attach the BLACK wire on the socket plate to
the BLUE wire on the switch housing. Secure with a
ceramic wire nut.
Step 7g. Align the three holes on the socket plate with the
screwholes on the switch housing. Insert three socket plate
screws (Pack G) and tighten until secure using the
screwdriver.
Step 7h. Remove the lightbulb shield from the socket plate.
Insert one end of the halogen bulb into the socket. Push
the end of the socket, then insert the other side of the
halogen bulb into the socket. Re-insert lightbulb shield.
Step 7i. Position the indentations in the outer rim of the
glass shade so that they line up with the tabs on the inside
surface of the fan light fixture rim.
Step 7j. Carefully lift the glass shade up inside the light
fixture as far as it will go. Rotate the shade in a clockwise
direction until it is held tightly in place by the three tabs.
Switch Housing
Socket Plate &
Bulb Shield
Glass Shade
Pack F
Switch Housing
Screws (3)
Pack G
Socket Plate
Screws (3)
Halogen Lightbulb
LIGHT FIXTURE HARDWARE (not to scale)
Switch Housing
Screws
Socket Plate Screws
Glass Shade
Halogen
Lightbulb
CAUTION:
The halogen bulb is very delicate and should not be
handled with bare hands. After removing it from
the box, grasp it gently by the plastic covering or a
soft cloth.
Ceramic
Wire Nuts
Lightbulb
Shield