9
Send Signal
LED
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired
speed.
LOW=Low speed MED=Medium speed HIGH=High speed
To turn off the fan, press the FAN OFF button.
airflow direction
To reverse the airflow, press the reVerse button. reVerse operates at any speed
whether the fan is on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the LIGHT button.
If you press the button for more than 0.7 seconds, it becomes a dimmer. The light
varies from “bright" to “dim” over approximately 8 seconds. If you continue to hold
the LIGHT button, this sequence will reverse when the light reaches its brightest or
dimmest level. Release the button when the desired level is reached.
Memory Feature
The last light fuction and fan speed will resume when power is turned back on.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains
the desired brightness level set previously.
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed cor-
rectly in the control.
Step 2. Turn the power off to the fan (from the circuit breaker)
for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and
push the HIGH, MED, and LOW buttons–in that order–within
20 seconds.
Step 4. The fan should now function properly.
CHAngIng TRAnSmITTER FREqUEnCy SETTIng
You will only have to change the dip switch settings in the
remote if you are using more than one fan in the same area
and want to control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off
for the fan you want to change.
step 2. open the battery door of the Versa•Touch control and
remove the batteries.
Step 3. Change the dip switch settings, assuring that they are
different from the previously installed Versa•Touch fan.
Step 4. Re-install the batteries and the battery door on the control.
Step 5. At the circuit breaker or fuse box, turn the power back
on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the HIGH,
MED, and LOW buttons (in that order).
CIRCUIT
bREAKER
OR fUSE bOx
pRESS IN THIS ORDER TO SET
NEW fREqUENCy:
1. HIgH 2. mED 3. LOW
DIp SWITCH
SET TO
“01001”
DIp SWITCH
SET TO
“10000”
Versa•Touch 2
CONTROL
(bACK)
LOW
mED
HIgH
LIgHT
fAN
Off
REVERSE
1
2
3
Note: You may want to label your controls to assure
you do not mix them up.
REmOTE OpERATIOn
warning!
Do not turn the power off at the circuit breaker, then
back on, for the previously installed Versa•Touch2
fan(s), as you may inadvertently change the
frequency settings for it as well.
Note: All fans leave the factory set to “00000.”
®