[8]
44808-01
04/03/2008
En
G
lis
H
operatIon
Storage
This appliance is for household use only.
1. Place the fan on a dry, safe, flat surface where it cannot fall or be pulled by the cord.
2. The Power/Speed Control should always be OFF before plugging or unplugging the
fan. Plug the fan into a grounded 120-volt AC electrical outlet (ordinary household cur-
rent). DO NOT use any other type of outlet. Make sure that the rated voltage of the fan
is the same as the power source before plugging it into the power source.
3. Use the Power/Speed Control to turn the fan “ON” or “OFF”.
4. To select the speed, move the Power/Speed Control from OFF to the desired speed
setting: O (off), I (low), II (medium), III (High).
5. To adjust the upward or downward flow of air, loosen the Angle Adjustment Knob
beneath the Fan Motor. Position the fan to the desired angle, and tighten the Angle
Adjust knob.
6. To make the fan oscillate, push the Oscillation Pin down. To stop the fan from oscillat-
ing, pull the Oscillation Pin up.
7. To adjust the height of your fan, hold the Telescoping Pole securely with one hand,
and twist the Height Adjustment Grip counterclockwise. While supporting the fan mo-
tor, raise or lower the Telescoping Pole to the desired height, then tighten the Height
Adjustment Grip.
1. AlWAYS store the fan in a dry place.
2. NEVER store the fan while it is still plugged in.
3. NEVER wrap the cord tightly around the fan.
4. DO NOT put any stress on the cord where it enters the fan, as it could cause the cord
to break.
Power/Speed
Control
Angle
Adjustment
Knob
Oscilation
Pin
