4
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CROSSBAR MOUNTING BRACKET INSTALLATION
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
GREEN
GROUND
WIRE
CEILING FAN
APPROVED
OUTLET BOX
RIDGE
SIDE
DOWN
CANOPY HARDWARE
CANOPY
CANOPY
HATCH
CANOPY LOCK WASHER (4)
CANOPY SCREW (4)
OUTLET BOX
MOUNTING
HARDWARE
Proceed with installation as follows:
Step 1.
Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the ceiling fixture out-
let box with the mounting hardware included with the outlet
box.
Using the screwdriver, tighten the screws firmly by
hand
only,
being careful not to bend the bracket by over tightening.
CEILING HARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked ‘
Approved for ceiling fan mounting
’. If it is not, a new
box must be installed.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked
acceptable for ceiling fan support using the mount-
ing hardware provided with the outlet box.
ADDITIONAL HARDWARE
2
1
/
4
″
x 8-32 ROUNDED
HEAD SCREW (2)
FLAT WASHER (2)
1
″
x 8-32 ROUNDED
HEAD SCREW (2)
E
STRADA
WARNING: Damp Location rated fans
require a Ground Fault Interrupter
(GFI). Use a weather-proof outlet box,
properly connect ground wires, and use
only under a weather-proof structure.
Summary of Contents for ESTRADA
Page 1: ...ESTRADA OWNER S MANUAL ...
