8
9' CEILING INSTALLATION
PIPE SCROLL HARDWARE
MOUNTING BRACKET INSTALLATION (CONT.)
Step 3. Align the slotted holes in the ceiling plate
with the pilot holes you drilled in the wood support
structure. For proper alignment use slotted holes
directly across from each other.
Step 4. Place a flat washer on each of the two
3” wood screws and pass the screws through the
slotted holes in the ceiling plate into the pilot holes
you drilled.
Step 5. Tighten the screws into the 9/64” pilot
holes; do not use lubricants on the screws. Do not
over tighten.
Note: The isolators should be flush against the
ceiling.
Joist
Ceiling Fan
Approved
Wiring Box
Washer
Wood
Screw
Allen
Wrench
Scroll
Assembly
ALLEN SET
SCREW
(pre-installed)
Note: On sloped ceilings, align the
ceiling plate opening toward the
top or peak of the room.
Step 1. Remove the Paper Shield from the top of
the motor.
Step 2. Loosen Set Screw on Motor Adaptor using
the provided allen wrench making sure that the end
of the Set Screw can not be seen within the motor
adaptor as shown in FIG 1. If so, you will need to
unscrew the Set Screw so that the tip of the Set
Screw does not remain in the path of the downrod.
Paper
Shield
Set Screw
Allen
Wrench
Scroll to
Motor
Screws (6)
FIG 1
Pipe
Assembly
Adapter
Cover
