CAS PB Series, Service Manual

Page: 6 / 20

6
Service Manual – PB Series
REV NO
: 2
4. Calibration Mode
4.1. General Calibration
Pressing and holding calibration switch press [POWER] key to go to calibration mode.
User can move to other mode by using [ZERO] key in the calibration mode.
User also moves to other sub-modes for each mode by using [TARE] key.
Please simply follow below procedure to move to other mode.
(1) Calibration Mode: Pressing and holding
“
Calibration Switch
”
press [POWER] key.
(2) It displays
“
CAL-0
”
after
“
CAL
”
, and it blinks the version of scale three times.
(3) Selecting menu: press [TARE].
(4) ENTER(Setting) : [TARE] key
MODE Function
CAL 1 Display normalized AD
CAL 2
Display Keypad infomation-
CAL 3
Weight Setting Mode
“UnLoad” [TARE]
→ →
“MIDD” [TARE] after loading for 1/3 weight
→ →
“FULL” [TARE] after loading for Full weight
→ →
“MIDD” [TARE] after loading for 1/3 weight “END”
→ →
CAL 4
Option Setting ( Refer to Table 1)
CAL 5 Display filtered Raw AD
CAL 7
% Calibration
CAL 8
Battery calibration
CAL 9 Gravity constant
CAL 10
Set calibration factor
“Unit” [TARE] select 0, 1 (0:kg, 1: lb) [TARE]
“CAPA” [TARE] select capacity [TARE]
“MCAPA” [TARE] select mid-capacity [TARE]
“W-dP” [TARE] Select Decimal Point [TARE]
“ 1 d ” [TARE] Select division [TARE]
“Dual” [TARE] Enable dual interval (0:disable, 1:enable) [TARE]
“tare” [TARE] Enable custom tare (0:disable, 1:enable) [TARE]
CAL 11 Set nation(00 : OIML , 01 : NTEP , 02: KOREA)