CAS Corporation ER PLUS LCD, Service Manual

Page: 11 / 65

ER
PLUS
Service Manual
11 9/27/2010
2. Calibration
2.1. General Calibration
Hold down “Calibration Switch” and “[POWER] key” to enter Calibration mode and then the
scale displays “CAL 1” after “onE”.
User can move to other menu by using [ZERO] key (Next) or [-] key (Previous).
User can also enter the sub-menus in each mode by using [TARE] key.
If you want to escape from the selected mode, Press the [C] key.
To confirm the modified setting, press the [TARE] key.
MODE Function
CAL 1
Display normalized AD value
CAL 2 Display Keypad information
CAL 3
Weight Setting Mode
“Unload” [TARE]
→ →
“MIDD” [TARE] after loading for 1/3 weight
→ →
“FULL” [TARE] after loading for Full weight
→ →
“MIDD” [TARE] after loading for 1/3 weight “END”
→ →
CAL 4
Optional Setting ( See “C-4 Table” on the next page)
CAL 5
Display filtered Raw AD value
CAL 6
Function settings on each Key ( See “C-6 Table” on the page 17)
CAL 7 % Calibration
CAL 8
Battery calibration
CAL 9
Gravity constant
CAL 10
Set calibration factor
“Unit”
Æ
[TARE]
Æ
select 0, 1 (0:kg, 1: lb)
Æ
[TARE]
“CAPA”
Æ
[TARE]
Æ
select capacity
Æ
[TARE]
“Mid”
Æ
[TARE]
Æ
select mid-capacity
Æ
[TARE]
“W-dP”
Æ
[TARE]
Æ
Select Decimal Point
Æ
[TARE]
“ 1 d ”
Æ
[TARE]
Æ
Select division
Æ
[TARE]
“Dual”
Æ
[TARE]
Æ
Enable dual interval (0:disable, 1:enable)
Æ
[TARE]
“tare”
Æ
[TARE]
Æ
Enable custom tare (0:disable, 1:enable)
Æ
[TARE]
CAL 11
Initialize settings(00 : OIML , 01 : NTEP , 02: KOREA),
Set AD as default (99), Set KEY as default (98)