SHENZHEN FLYING INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: [email protected]
lamp 3 is turned on. The relays of the receivers 1, 2, 4 are deactivated (disconnect the terminals B and C, connect the terminals A and C), and the
lamps 1, 2, 4 are turned off.
Press button 4 of the transmitter: The relay of the receiver 4 is activated (connect the terminals B and C, disconnect the terminals A and C), and the
lamp 4 is turned on. The relays of the receivers 1, 2, 3 are deactivated (disconnect the terminals B and C, connect the terminals A and C), and the
lamps 1, 2, 3 are turned off.
Wired control terminals:
The receiver has wired control terminals, and you can connect external devices, sensors, or manual switches to the receiver's manual terminals, then
use them to trigger the receiver.
1) By low level signal:
You can connect external devices (with low level output signal) to terminal 1
(Signal−),
and terminal 2 (), then the external device’s output
signal can control the receiver.
When the external device outputs low level signal to terminal 1 and 2, the relay is activated (connect the terminals B and C, disconnect the terminals
A and C), and the lamp is turned on.
When t
he
external
device
stops
to output
signal, the relay is deactivated (disconnect the terminals B and C, connect the terminals A and C), and the
lamp is turned off.
2) By NO/NC contact:
You can connect manual switch to terminals 1 and 2, then you can use manual switch to control the receiver.
When connect terminals 1 and 2, the relay is activated (connect the terminals B and C, disconnect the terminals A and C), and the lamp is turned on.
When disconnect terminals 1 and 2, the relay is deactivated (disconnect the terminals B and C, connect the terminals A and C), and the lamp is
turned off.
How to pair the transmitter to the receiver:
1) Press the learning button of receiver, signal LED on the receiver is on, it means the receiver enters the learning status.
2) Press any one button on transmitter, if signal LED flashes quickly 15 times and turns off, it means learning is successful.
3) When receiver is in the learning status, press again the learning button, if signal LED turns off, it means learning process was discontinued.
4) The receiver can learn several transmitters with different codes.
Delete all transmitters:
We have learned transmitter to the receiver. If you don’t want the receiver to work with the transmitter, you can delete all codes of transmitters, which
are stored in the receiver.
Operation: Press and hold the learning button of receiver until signal LED flashes slowly; then release the button, signal LED keeps slow flash. That
means all stored codes have been deleted successfully.
