OWNER’S MANUAL
WINTERIZATION AND STORAGE
168
3237 • X6 02/2018
10
6 ]
On the DC control center:
a ]
Switch ON the SYSTEMS DC MAIN circuit
breaker.
b ]
Switch ON the WASHDOWN PUMP circuit
breaker.
7 ]
Once a steady stream of antifreeze flows from the
washdown fittings, switch OFF the WASHDOWN
PUMP circuit breaker.
8 ]
Disconnect the hoses to the washdown fittings and
close valves.
9 ]
Reconnect the hose that was disconnected in step
2.
BILGE
See
“Bilge Water Pumping System” on page 106
for a description of the bilge system.
Bilge Drainage Procedure
1 ]
Open the hull drain. Leave the drain open while the
yacht is in storage.
2 ]
Remove all water from the bilge.
3 ]
Clean the bilge as described in
SANITATION SYSTEM
Remove the yacht from the water before performing
the sanitation system procedure. Refer to the Original
Equipment Manufacturer (OEM) information for more
information on winterizing the sanitation system.
“Sanitation System” on page 168
for a
description of the sanitation system.
If your sanitation system has the optional overboard
discharge system, see
1 ]
Empty the waste tanks as described in
the Waste Tank and/or Optional Gray Water
freshwater used in flushing the tanks as possible.
2 ]
If the toilet uses seawater to flush, follow steps
2a - 2d. Otherwise, proceed to step 3.
a ]
Close the seacock that supplies seawater to the
toilet.
b ]
Disconnect the toilet seawater hose from the
seacock.
c ]
Flush the toilet until all water is drained from the
seawater hose.
d ]
Reconnect the seawater hose to the seacock.
Leave the seacock closed.
Damage can occur to the freshwater system by using the
wrong type of antifreeze. Use a non-toxic, nonalcohol, RV-
type (pink) antifreeze. Damage resulting from using the
incorrect antifreeze is not included under the warranty.
NOTICE
3 ]
Flush 4 gal (15.1 L) of non-toxic recreational vehicle
antifreeze through the toilet. Keep the antifreeze in
the waste tanks while the yacht is in storage.
4 ]
When removing the yacht from storage and
preparing to use the yacht again:
a ]
Flush 5 gal (18.9 L) of freshwater through each
toilet.
b ]
Empty the waste tanks as described in
“Emptying the Waste Tank and/or Optional
.
c ]
If the toilet uses seawater to flush, open the
seacock supplying seawater to the toilet.
d ]
Flush the toilet a few times to prime the
sanitation system.
e ]
Charge the waste tanks by adding deodorizer.
Any RV deodorizer is acceptable.
C34_Coupe.indb 168
2/8/2018 3:44:29 PM
