Carver Yachts 38 Super Sport, Owner'S Manual

Page: 110 / 126

4 3827 • U2 3/10
W
interization and
S
torage
S
ection
8
Preparing the System for Use Again
When you remove your boat from storage and prepare to use it again,
flush the entire fresh water system with fresh water. Nontoxic antifreeze is
colored, so the water system is adequately flushed when uncolored water
flows from all of the faucets and shower heads. You may need to fill the
water tank more than once to flush the system.
Raw Water Washdown
Before performing this procedure on the optional transom raw water
washdown, your boat should be pulled from the water.
Refer to Section 4 - Raw Water Washdowns for a description of your boat’s
raw water washdown system.
1. Close the seacock that supplies the raw water washdown pump
with seawater.
2. Disconnect the end of the hose that is attached to the washdown
side of
the seacock.
3. Place the disconnected hose end into a bucket that contains about
a gallon of nontoxic recreational vehicle antifreeze.
4. Remove the hose from the transom raw water washdown fitting.
5. Place a bucket under the washdown fitting to catch the antifreeze,
which can be reused.
6. On the Safety Breaker Panel:
a. Turn the Accessory Battery master disconnect switch to the
ON position.
b. Switch the Main - One circuit breaker ON.
7. On the DC Control Center:
a. Switch the Main circuit breaker ON.
b. Switch the Washdown Pump circuit breaker ON.
8. When a steady stream of antifreeze flows from the washdown
fitting, switch the Washdown Pump circuit breaker OFF.
9. Reconnect the hose to the washdown fitting.
10. Reconnect the hose that was disconnected in Step 2.
Bilge
Refer to Section 4 - Bilge System for a description of your boat’s bilge
system.
1. Open the hull drain. Leave the drain open while your boat is in
storage.
2. Remove all water from the bilge.
3. Clean the bilge as described in Section 7 - Bilge System.
Open Closed
https://www.boat-manuals.com/