Carver Yachts 36 SEDAN, Owner'S Manual, Page: 60 / 135

48 3428 • 3/06
INTERNAL SYSTEMS SECTION 4
8. Verify that seawater is being pumped through the air conditioning units. As
the seawater exits the units, it flows out of a discharge thru-hull fitting. Refer
to Section 9 - Thru-Hull Fittings for the location of this thru-hull fitting.
9. Use the controls for each air conditioning unit to set the desired temperature.
The controls are located in the salon and master stateroom. Refer to the
OEM information for details on operating the air conditioning controls.
Fresh Water System
The capacity of your boat’s fresh water system is approximately 86 gallons.
The water is divided between one 75-gallon fresh water tank and an 11-gallon
water heater. The water tank and water heater are located beneath a hatch in the
cockpit. Refer to Section 9 - Interior Hatches for the exact location of the water
tank and water heater.
Filling the Water Tank
The fresh water tank is filled through a single deck fitting with a plate labeled
“WATER.” The plate is located on the port transom. Refer to Section 9 - Deck
Plates for the exact location of this plate.
NOTE: Thoroughly flush and sanitize the water system before initial use and at least
once each season.
Do not overfill the water tank or leave the fill hose unattended while the
tank is being filled. Overfilling the tank could cause it to rupture.
Put only clean, fresh water into your water tank. The tank is full when water is
discharged from the water tank vent, which is integral to the deck fitting.
Pressurizing and Priming the Water System
Perform the following ONLY after the fresh water tank is full.
1. Turn the accessory battery master disconnect switch to the “ON” position.
2. On the Safety Breaker Panel, switch the Auto Sump - Forward circuit
breaker “ON.”
3. Partially open all cold water faucets, including the faucets for the optional
transom hand shower and bow and transom fresh water washdowns.
4. On the DC Control Center, switch the DC Main circuit breaker “ON,” then
switch the Pressure Water Pump circuit breaker “ON.” This activates the
boat’s pressure water pump, which pressurizes the water system. The pump is
located beneath a hatch in the cockpit. Refer toSection 9 - Interior Hatches
for the exact location of the water pump.
A Tip From Carver!
If your boat will be left unattended for at least a few days, switch the Pressure
Water Pump circuit breaker on the DC Control Center “OFF.” If this breaker is
left on, pressure in the fresh water system may fall and cause the water pressure
pump to engage. If this happens frequently, it could discharge your batteries.