Cartrend 10728, Instructions For Use Manual

Page: 23 / 104

23
GB Instructions for use
uSe
Information about use
• Please remember, on some vehicles the 12 V car socket only
works if the ignition is on.
• always unplug the car plug from the 12 V car socket. When doing
so, always pull by the car plug, never the cable.
• the tyre pressure increases as the temperature rises. the recom-
mended tyre pressure is typically specified for cold tyres (approx.
20 °C). Please refer to the owner’s manual for your vehicle.
• Do not check the tyre pressure on warm tyres (e.g. after long
trips).
attention!
Observe the specifications of the manufacturer of the product. Do
not use the compressor to inflate flotation devices!
Switching the compressor on/off
1. Plug the connecting plug [16] into the mains socket [10] on the
device.
2. Plug the 12 V car plug [15] into the vehicle’s 12 V car socket.
3. Wait a few seconds until the display [11] reads 0.0. When the de-
vice is not being used for 50 seconds, the display will automati-
cally switch off to save energy.
4. Perform the desired tasks as described in the following chapters.
5. unplug the 12 V car plug [15] from the vehicle’s 12 V car socket.
6. unplug the connecting plug [16] from the mains socket [10] on
the device.
Changing the pressure unit (PSI, bar or kPa)
repeatedly press the pressure unit button "uNIt" [13] until the dis-
play [10] shows the desired pressure unit.