Version 18.11.2015
Pa
ge
8
Connecting video-interface and CAN-box
The CAN-bus box reads digital signals from the CAN-bus and converts them for the video-
interface. ACC +12V max. 0.5A (red of 6pin) and reverse gear +12V max. 0.5A (green of 6pin)
constant signal. Video-source switching (white of 6pin) as +12V impulse. Addi
ti
onally there is
a data exchange, e.g. for steering wheel posi
ti
on for driving path lines (grey of 6pin).
Connect black female 10pin Micro
fi
t connector of the Quadlock harness to the male
10pin Micro
fi
t connector of the CAN-box.
Note:
Check LEDs on CAN-box a
ft
er reconnec
ti
ng the ba
tt
ery, two must be on.
Connect white female 6pin Molex connector of the 6pin to 8pin cable to the male
6pin Molex connector of the video-interface.
Connect black female 8pin Micro
fi
t connector of the 6pin to 8pin cable to male 8pin
Micro
fi
t connector of the CAN-box.
Note:
Check LEDs on video-interface a
ft
er reconnec
ti
ng the ba
tt
ery, one must be on.
Note:
The CAN-box is not compa
ti
ble with all vehicles. If the CAN-box does not deliver ACC
to pin2 of the video-interface or blocks the vehicle CAN, it is possible to install without CAN-
box. In this case see also note in chapter a
ft
er-market rear-view camera if one is supposed to
be connected.
