SA-430 Installation and Operating Instructions Page 7
03/22/02 CP4854B
When connected to the red lead, make sure that the ignition switch controls the power to that
connection. This prevents the panel lights from being continuously on.
White: Control
- Connect white leads from amplifier and control head. The connection may
be extended with any size wire. Route this lead away from the transmitter antenna lead to
prevent R.F. interference being fed to the siren amplifier.
Green: Auxiliary Input
- Used for Siren control.
Performs same function as Siren button. Connect
to a normally open switch or to horn ring circuit.
Circuit may connect to either positive or negative.
When connected to horn ring circuit, use a SPDT
switch to connect horn ring to either vehicle horn
or to manual control circuit.
NOTE: Permanent disconnection of the vehicle
horn is NOT recommended.
NOTE: be sure to cut lead short if not used and
insulate with electrical tape.
HORN
RING
SWITCH
SPDT
SWITCH
AUX
HORN