Page 6 of 16
SA-430-10 Installation and Operating Instructions
CP4854E
03/31/10
OPTION SWITCHES
An 8-position DIP switch on the remote amplifier may be changed to select various options.
SW-1 Two-Tone
- Turn this switch on to replace Phaser tone with Two-Tone.
SW-1 and 2 Phaser Disable
- Turn on both switches to disable Phaser tone.
SW-3 Horn Disable
- Turn this switch on to disable Horn tone.
SW-4 Horn Ring Cycler 2 (HRC2) -
Turn on this switch to enable this feature. Also connect
the auxiliary input to the horn ring or other switch. While the siren is in standby, tap the horn
ring to bring the unit out of standby into Wail tone. Repeatedly tapping the horn ring will cycle
through Wail, Yelp, and Phaser tones. Tapping the horn ring twice quickly will stop the siren
tones and return the unit to standby. Pressing and holding the horn ring will produce Horn tone
until released. Then the siren will return to its previous siren tone or standby.
NOTE
: Earlier units with S/N lower than 04190000 have a different version of
HRC
. In this
case the siren tones cycle through Standby, Wail, Yelp, and Phaser. The tone is stopped by
cycling to Standby.
SW-5 - Not Used… Leave Off.
SW-6 and SW-7 Cutout Input Polarity
- The cutout input is normally disabled. Set the
activation polarity as follows:
Positive Activation - SW-6 and SW-7 OFF.
Negative Activation - SW-6 and SW-7 ON.
Disabled - SW-6 ON and SW-7 OFF.
SW-8 - Not Used… Leave Off.
Option Switches
On Remote Amp
ON
1
2
3
4
5
6
7
8
Option Switches
Default Setting Shown (Switch 6 is ON)
