Commissioning of the electronics unit
(Required 6 Channel Radio control system for exampel Carson Reflex)
Plug the supplied servo cable (JR) to the elctronics unit (see Fig.No.14) from channel 1 to
channel 6 and connect to your receiver in the same order (Channel 1 – Channel 6).
- Zero alignment/Neutral setting from transmitter and electronic unit
o 1) Press the Push button – 1 (see Fig. No. 8) for approx. 1 Sec. and the LEDs (Red
/ Yellow / Green) will light up all (all Drives are disabled). You are now in the
Setting menu „Zero alignment/ neutral setting”.
o 2) Press the Push button – 2 (see Fig. No. 9) for approx. 1 Sec. and the LEDs (Red
/ Yellow / Green) light up briefly and go out again. The Green LED begins to
flash and the electronic unit is ready for the adjustment. Continue with the sticks
in all the final positions („Direction and order are not decisive“), and taking note
of the yellow LED, if this does not illuminate the electronics take over all
maximum of rashes. (While this adjustment continues to flash the green LED).
o 3) To save the zero alignment / neutral setting of the transmitter and electronic unit
press repeatedly the push button - 2 (see Fig. No. 9) for approx. 0.5 Sec. (The
red LED lights up briefly and the green LED will light). The settings are now
complete and saved.
- Functions of the left cross stick:
o Drive function (forward / backward)
-Cross stick forward / backward
o Steering (left / right)
-Cross stick to the left / to the right
o Turn on the spot (max. 70% of the power)
-Cross stick to left stop /or/ right stop
- Function of the right cross stick:
o Tipping shovel (left / right)
-Cross stick to the left - fill / to the right - dump
o Lowered mast up or down
-Cross stick backward – upwards / forward – downwards
Functions of the switches (on/off/on) and push button (on/off/on)-combinations:
Switch position "above" and push button up:
- Light 1 on / off (Work lights, front / outside) / Right cross stick - normal functions
Summary of Contents for LR634
Page 17: ......
