GB
// 8
LIGHTING MODULE
The lighting module has 4 outputs (each with a max. 100mA) and there is a choice of 6 different settings. With a 3-way tumbler switch or
2/3-way momentary switch (on-off-on), two settings can be programmed and activated via the remote control.
ASSEMBLING THE ROTATING BEACON
1 Determine installation location of rotating beacon(s) on cab /
vehicle
2 Make a mounting hole
3 Installation materials for compensating for the roof slope are
included in the scope of delivery.
CONNECTING THE ROTATING BEACON
bore a hole
Connect the module directly to a free channel on the receiver. Pay
attention to the polarity.
If the module and outputs are powered by the receiver (BEC), the
jumper must be inserted on the left. In this case, do NOT connect
the cable for the external power supply. The output voltage for
this setup scenario is 5 V (BEC voltage from the receiver). The
outputs can also be powered by an external power supply with
a maximum voltage of 7.2 V. In this case, the jumper must be
inserted in the right-hand position. Ensure that the connections
are made with the correct polarity.
WARNING!
Connecting the cable with reverse polarity will result in
damage or a defect!
Summary of Contents for 500907010
Page 15: ...15 NOTIZEN NOTES ...
