7
CARSON Reflex Stick PRO 500500046
GB
Operating Procedure
BEC-System/Connections to Receiver
Many publications say that the setup sequence
for the transmitter and receiver don’t play a role
anymore with 2.4 GHz sets. However, we recommend
sticking to the sequence typical for previous sets.
• Before operation: Connect the drive battery
to the control unit. First turn on the transmitter,
then the receiver.
BEC receiver:
Battery eliminator is installed in the receiver circuitry.
The receiver gets supplied with current through the
drive battery that runs the motor. NiMH battery from
6 V to 8.4 V can be used for the receiver. Batteries of
• After operation: Disconnect the battery from the
control unit. Turn the receiver off, and then the
transmitter.
• Before and after operating the transmitter, make
sure that trim is in the desired place and that all
checks have been made.
higher voltage may damage the receiver and servos.
Use only a speed controller which has the exclusive
connector for the BEC system.