Carrom 521, Instructions Manual

Page: 9 / 16

8
Step 7
Attach the GOALIE COVER PLATE (item
#5) to both ends of the cabinet. Use (2) #6
x 5/8” FLATHEAD SCREWS (item #7) to
secure it to the end with the opening left
over the leg hole. Assemble the SCORER
ROD, SCORE BEADS & SCORER END
PIECES (item #21) to the top on the end
panel by centering the scorer over the
holes in the GOALIE COVER PLATE (item
#5) and fasten with (2) screws (provided in
accessory box) to the top of the end panel.
No pre-drilling is necessary.
Screw in the (8) DOUBLE HEADED
SCREWS (item #3) into the bottom holes
of each side & end. (The drink holder
corners have slots that will slide over
these screws.) Attach (4) DRINK HOLDER
CORNERS (item #20) to each corner of
cabinet by sliding them down over the
top edge of the cabinet. Attach the drink
holder corners by carefully engaging the
(2) double headed screws on the corners
of the cabinet with the slots on the inside
of the corners. Drink holder corners should
fit snugly.
Level the game by turning the LEG
LEVELERS (item #16) either in or out
to raise or lower the corners. The table
should be leveled in both the lengthwise
and width direction.
Step 8
Work from one side of the table, and start with the BLACK or YELLOW PLAYERS (item
#32). Notice that there are three different types of RODS (items #22, #23, and #24), for
each team.
IMPORTANT: RODS MUST BE CLEANED PRIOR TO ASSEMBLY!
Apply lubricant to a cloth and clean rods prior to assembly.
Occasional light lubrication will make rods slide smoother.
Select (2) 3-MAN RODS (item #22), (1) 2 MAN ROD (item #23), and (1) 5 MAN ROD
(item #24). Notice that there is a hole near the end of each rod. On the “hole end” of
each rod, place the WOOD HANDLE (item #25) with (1) #10-32 x ¾” SCREW (item #28)
through the handle and into the rod.