OPERATING INSTRUCTIONS
Airflow direction control
Adjust the air flow direction properly otherwise it
might cause discomfort or cause uneven room
temperatures.
Adjust the horizontal/vertical louver using the remote
controller. For some models, the vertical louver can
only be adjusted manually.
Perform this function while the unit is in operation.
Use the remote controller to adjust the air flow direction.
The vertical/horizontal louver changes 6 degree in angle
for each press, or swing up and down automatically.
Please refer to the REMOTE CONTROLLER OPERATION
MANUAL
for details.
To set the horizontal/vertical air flow direction
For some models, the vertical louver can only be adjusted
manually. Move the deflector rod manually to adjust the air
flow in the direction you prefer.
:Do not put your fingers into the panel of
blower and suction side.
IMPORTA NT
The high-speed fan inside may
cause danger.
Do not operate the air conditioner for long periods with
the air flow direction set downward in cooling or
dehumidifying mode. Otherwise, condensation may
occur on the surface of the horizontal louver causing
moisture to drop on to the floor or on furnishings.
When the air conditioner is started immediately after it
was stopped, the horizontal louver might not move for
approximately 10 seconds.
Open angle of the horizontal louver should not be set
too small, as COOLING or HEATING performance may
be impaired due to too restricted air flow area.
Do not move the horizontal louver manually, otherwise
the horizontal louver will be out of sync. Please cease
operating, unplug power for a few seconds,then restart
the air conditioner.
Do not operate unit with horizontal louver in closed
position.
CAUTION
,,
,,
OPERATING INSTRUCTIONS
NOTE: This manual does not in cl ude Remote Controll er Operatio ns, s ee the
<<Remote Controller Instruc tion>> pac ked with th e unit for details .
D eflector rod
Ra nge
Range
Manual c ontrol button
Suspensi on bars
Manua l control button
AU TO /COO L
AU TO /COO L
（ ）
1
（ ）
2
Manual operation
Operating temperature
Manual switch
Manual switch
Mode
Temperature
Room temperature
Outdoor tem perature
1. Optimum performance will be achieved within these operating temperatur es.If air
conditioner is used outside of the above conditions, certain s afety protect ion features
might come into operation and cause the unit to function abnormally.
2. If the air conditioner r uns for a long time in cooling mode and the humidity is high(over
80%) , condensed water may drip out of the unit. Please sets the vertical air flow louver to
its maximum angle (vertically to the floor), and set HIGH fan mode.
Suggestio n:
For the unit adopts an Electric Heater, when the outside ambient temperat ure
is below 0 C(32 F), we strongly recommend you t o keep the machine plugged in order to
guarantee it running sm oothly.
O
O
NOTE:
Cooling operation
Heating operation
Drying operation
-15
50
5
122
For the models with low
temperature cooling system
0
50
32
122
-15
30
5
86
0
50
32
122
Open and lift the front panel up to an angle
until it remains fixed with a clicking sound.
For some models, please use suspension
bars to prop up the panel.
Close the panel firmly to its original
position.
One press of the manual control switch will
lead to the forced AUTO operation. If press
the switch twice within five seconds, the unit
will operate under forced COOL operation.
This switch is used for testing purposes
only. You had better not choose it.
To restore the remote controller operation,
use the remote controller directly.
CAUTION:
1
3
2
●
●
NOTE:
The unit must be turned off before
ope rating the ma nual control button. If the
unit is operational, continue pressing the
manual control b utton until th e unit is off.
17 C ~32 C
(62 F~90 F)
O
O
O
O
0 C~30 C
(32 F~86 F)
O
O
O
O
10 C ~32 C
(50 F~90 F )
O
O
O
O
Units are equipped with a switch to run emergency operation mode. It can be accessed by
opening the front panel. This switch is used for manual operation in cas e the r emote controller
fails to work or maintenance necessary.
