Asense CO2 Duct Sensor
Installation and Operation
#NSA-ASENSE-D-LCD-REL, NSA-ASENSE-D-REL
– 11/14/2019
Specifications subject to change without notice.
Catalog No. 11-808-745-01
Page
7
of
9
Connecting ASense to UIP5 software
NSA-TTL-232R-3V3 programming cable is required.
1. Download the UIP5 software from the SenseAir website.
http://www.senseair.com/products/software/uip-5/
2. Plug the programming cable into a USB port, and go into Device Manager on the computer to determine which port is
being used.
3. Open the UIP5 software.
4. Power the sensor on and plug the programming cable into the sensor. The programming cable must have the black
wire with the arrow connected towards the top of the connector on PCB as shown in Figure 1.
Figure 1
5. Click the
Meter
tab at the top of page. In the
Connection Configuration
window:
a. Select
Com Port
.
b. Set
Baud rate
to 9600.
c. Set
Parity
to NONE.
d. Click
Save
.
Figure 2
6. Go to
Meter
, and click
Connect
.