HDB - IR
GB - 4
1. Operating mode (from left to right):
• Ventilation (fan only)
• Heating (according to the Unit configuration)
• automatic(according to the Unit configuration)
• Cooling and dehumidification
• Dehumidification only
2. Signal transmission symbol
3. Temperature selected
4. Address selector
5. Temperature unit of measurement (°C or °f)
aM
PM
A
B
1
2
f
3
5
7
8
10
12
13
1
2
4
6
9
11
14
15
6. Unit configuration
7. Batteries exhausted indicator
8. Louvre positioning (Flap)
9. fan speed
10. Personalisation active
11. On timer selected
12. Night timer active
13. Daily timer active (Everyday)
14. ON timer, OFF timer and current time
15. Off timer selected
Display of selected functions
General information
The remote control works only with hydronic units.
For installation instructions of this unit, refer to the relevant
manuals.
The operating setting to the unit are sent by the remote control
through an infrared ray.
The emitter is placed on top of the remote control just over the
display.
For this reason, the remote control must be directed towards the
unit before sending any message and care must be taken that no
obstructions are between the remote control and the unit.
a small black arrow on the display left side indicates that the
message has been correctly sent.
An acoustical sound (beep) indicates that the message has been
correctly received by the unit.
• For trouble-free installation, which should be carried out by a
qualified installer.
• Follow all current national safety code requirements.
• after installation thoroughly test the system operation and
explain all system functions to the owner.
• Leave this manual with the owner for consultation during future
periodic maintenance.
• Dispose of packaging material in accordance with local
requirements.
• The manufacturer denies any responsibility and warranty shall
be void if these installation instructions are not observed.
• Inspect equipment for damage due to improper transportation
or handling: file an immediate claim with the shipping company.
Do not install or use damaged units.
• In case of any malfunctioning turn the unit off, disconnect the
mains power supply and contact a qualified service engineer.
