background image

 ©2022 Carrier. All rights reserved.

Edition Date: 9/22

Catalog No: IM-EVD-ESD4X-03

Replaces: IM-EVD-ESD4X-02

EVD4X, ESD4X, WMVC, WMSC: Installation Instructions

Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.

7

condensate line (with appropriate trap) should be run from the unit into

the  pan.  Any  condensate  in  this  external  condensate  pan  should  be

drained  to  a  noticeable  place. As  an  alternative  to  using  an  external

condensate  pan,  some  localities  may  allow  the  running  of  a  separate

¾-inch (19 mm) condensate line (with appropriate trap) per local code to

a  place  where  the  condensate  will  be  noticeable.  The  owner  of  the

structure must be informed that when condensate flows from secondary

drain  or  external  condensate  pan,  the  unit  requires  servicing  or  water

damage  will  occur. To  further  protect  against  water  damage,  install  a

float switch to shut the unit off if the water in the secondary pan gets too

high. 

A10216

Fig. 9 – Condensate Drain to Waste Line

Waste Line Connection

If the condensate line is to be connected to a waste (sewer) line, an open

trap must be installed ahead of the waste line to prevent escape of sewer

gases (

Fig. 9

).

Humidifier Application

When  installing  a  humidifier  in  a  system  which  contains  a  V-coil,

consideration must be given to location of coil slabs (

Fig. 10

).

1. The humidifier should be mounted to the supply plenum or return

duct whenever possible.

2. Ensure that humidifier has adequate airflow.

A200229B

Fig. 10 – Humidifier Application

Care and Maintenance

To continue high performance and minimize possible equipment failure,

it is essential that periodic maintenance be performed on this equipment.

Consult your local dealer as to the proper frequency of maintenance, but

it should be done at least annually.
The ability to properly perform maintenance on this equipment requires

certain mechanical skills and tools. If you do not possess these, contact

your dealer for maintenance. The only consumer service recommended

or required is filter replacement or cleaning on a monthly basis.

Condensate
Line

Trap

Sewer Line

Air Gap Above
Liquid Level

CAUTION

!

ENVIRONMENTAL HAZARD

Failure to follow this caution may result in environmental damage.
Remove and recycle all components or materials (i.e., oil, refrigerant,

etc.) before unit final disposal. 

Summary of Contents for EVD4X








Reviews: