2
32802000301
Specifications subject to change without notice.
A NOTE ABOUT SAFETY
Any time you see this symbol
in manuals, instructions and on the
unit, be aware of the potential for personal injury. There are three levels
of precaution:
DANGER identifies the most serious hazards which will result in
severe personal injury or death.
WARNING signifies hazards that could result in personal injury or
death.
CAUTION is used to identify unsafe practices which could result in
minor personal injury or product and property damage.
NOTE is used to highlight suggestions which will result in enhanced
installation, reliability, or operation.
PERSONAL INJURY, DEATH AND / OR PROPERTY
DAMAGE HAZARD
Failure to follow this warning could result in personal injury,
death or property damage.
Improper installation, adjustment, alteration, service,
maintenance, or use can cause explosion, fire, electrical shock,
or other conditions which may cause personal injury or
property damage. Consult a qualified installer, service agency,
or your distributor or branch for information or assistance. The
qualified installer or service agency must use
factory−authorized kits or accessories when modifying this
product.
Read and follow all instructions and warnings, including labels
shipped with or attached to unit before operating your new air
conditioner.
!
WARNING
GENERAL
The ducted fan coil unit provides quiet, maximum comfort. In
addition to cooling and/or heating, the ducted fan coil unit matched
with an outdoor condensing unit filters and dehumidifies the air in
the room to provide maximum comfort.
IMPORTANT:
The ducted fan coil unit should be installed by
authorized personnel only; using approved tubing and accessories. If
technical assistance, service or repair is needed, contact the installer.
The ducted fan coil unit can be set up and operated from the remote
control (provided). If the remote is misplaced, the system can be
operated from the “Auto” setting on the unit.
OPERATING MODES
The ducted fan coil unit has five operating modes:
S
Fan only
S
Auto
S
Heating (heat pump models only)
S
Cooling
S
Dehumidification (DRY)
Fan Only
In FAN ONLY mode, the system filters and circulates the room air
without changing room air temperature.
Auto
In AUTO mode, the system automatically cools or heats the room
according to the user−selected set point.
NOTE: AUTO mode is recommended for use on single zone
applications only. Using Auto changeover on multi−zone applications
could set an indoor unit to STANDBY mode, indicated with two dashes
(−−) on the display, which will turn off the indoor unit until all the
indoor units are in the same mode (COOLING or HEATING).
Heating is the system’s priority mode. Simultaneous HEATING and
COOLING is not allowed.
Heating
In HEATING mode, the system heats and filters the room air.
Cooling
In COOLING mode, the system cools, dries and filters the room air.
Dehumidification (DRY)
In DEHUMIDIFICATION mode, the system dries, filters and
slightly cools the room air temperature. This mode prioritizes air
dehumidification but it does not take the place of a dehumidifier.
WIRELESS REMOTE CONTROL
The remote control transmits commands to set up and operate the
system. The control has a window display panel that displays the
current system status. The control can be secured to a surface when
used with the mounting bracket provided.
WIRED REMOTE CONTROL (OPTIONAL)