4
Before starting the freezer, follow these important first steps:
Set-Up
Instructions
Inspection for Damage
•
Inspect the freezer and packaging for damage such as a fork truck can cause, or
look for bent corners from dropping the cabinet. If hidden damage is found after
uncrating, immediately call the delivery carrier and request an inspection. Retain
all packaging and crating materials until the inspection is complete.
Uncrating and Set-Up
•
Using a utility knife with a sharp, short blade, cut along the perimeter of the carton
as indicated.
•
Lift the carton off the freezer.
•
Using a pair of wire cutters, carefully snip the cable tie from the basket. Set the
basket to the side.
•
Remove the cardboard box containing the glass lid and casters from the freezer.
This box will contain the following items:
• One (1) wrench
• Sixteen (16) screws
• Four (4) casters
• One (1) upper glass lid
• One (1) lower glass lid
Casters:
•
With an assistant, tilt the freezer until it is resting on its back. Take care to protect
the back from being scratched during this process.
•
Using the wrench provided and the sixteen (16) screws (Figure 1), install all four
(4) casters in the tapping holes in the bottom of the unit. Tighten securely.
•
With an assistant, tilt the freezer back up onto the casters.
•
Return the wire basket to the unit, resting it on the side rails of the freezer.
Glass Lid:
•
There are two glass lids, a smaller one that fits in the lower track of the freezer and
a larger one that fits in the upper track. The lower track has two (2) round retaining
studs and the upper has four (4) round retaining studs (Figure 2).
•
Install the lower glass first. Again, the lower glass is the smaller of the two. It has
a flexible vinyl seal (Figura 4) and a lock plate. The flexible seal should be facing
up and positioned on the end away from the two (2) round retaining studs. Place
the panel in the center and slide along the lower track until it is secure under the
two retaining studs.
•
Place the upper glass panel over the lower panel already in place. Slide it over the
lower lid past the flexible seal. You will notice a slight resistance with the lower lid
gasket. Slide the upper panel under the four (4) studs on the upper track of the
frame.
•
When properly installed, there is a seal formed by the flexible vinyl seal between
the two glass lids.
Lock:
•
To lock the glass lid, simply insert the key and lock into the lock plate. Turn key
clockwise. Remove key and store in safe place.
Figure 3
Figure 1
Figure 2
Figure 4
Lock
Upper Glass Lid
Key
Lower Glass Lid
Flexible Vinyl
Seal
Lock Plate
Upper
Track
Lower Track
Upper Track
(4) Round Retainer
Studs
Lower Track
(2) Round
Retainer Studs
Summary of Contents for B13
Page 9: ......
