T-354
7–42
Materials needed:
1. Cut two square pieces of 3mm thick (1/8-inch) aluminum or stainless steel approximately 40mm (1- 5/8”)
square. These squares will serve as backing plates.
2. Two nuts, bolts (10-24 x 1") and washers for each insert that needs repair.
a. Drill a 1/4” hole in the center of each square backing plate.
b. Pass the bolts through the bolts holes in the door hinge, then through the control box at the location
where the hinge insert pulled out.
c. From inside the control box, slide the backing plates over the bolts and secure in place with the washers
and nuts.
Figure 7.33 Door Hinge Repair
Table 7–2 Crack, Chip and Hole Repair Kit
ITEM
DESCRIPTION
PART NUMBER
QTY
1
Crack Repair Kit - Includes
76-00724-00SV
1
2
Fiberglass Patch Kit (Loctite FK-98 or 80265)
76-00724-00Z
10
3
Sikaflex 221 Adhesive Sealant (Sikaflex 232-361)
02-00067-02Z
10
4
Instruction Sheet
98-02339-00
10
Summary of Contents for 69NT40-541-306
