SuSpenSion Strut Support
Model no:
VS3847
thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. Safety
WarninG!
Wear approved eye protection. Wear appropriate Personal Protective equipment. A full range of Personal
Protective equipment is available from your Sealey dealer.
WarninG!
ensure that Health & Safety, local Authority Regulations and general workshop practice Regulations are adhered to
when using tools.
8
Do not
use tools if damaged.
8
Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
9
ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
9
Wear suitable clothing to avoid snagging.
Do not
wear jewellery. Tie back long hair.
9
Account for all tools, parts and components being used.
Do not
leave these in or near the engine.
9
Return tools to suitable storage after use.
8
These Instructions are provided as a guide only.
9
Always refer to the vehicle manufactures’ service instructions or a proprietary manual to establish the correct procedure and data.
WarninG!
The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The
operator/ user must apply caution and common sense (good practical sense).
note:
For stability the VS3847 must only be used in conjunction with a transmission jack with a minimum base size of 560mm x
570mm and a ram size of 30mm diameter.
introDuction
2. Specification
Model no. .................................................................. VS3847
Transmission jack ram size maximum ....................... Ø30mm
Transmission jack base size minimum ........560mm x 570mm
3. operation
3.1.
Fit the VS3847 fully onto the transmission jack ram and finger tighten the butterfly screws provided (fig.2).
3.2.
Remove the hex bolts and the closing plate, fit the VS3847 around the suspension leg beneath the lower spring cup (fig.2).
3.3.
Refit the closing plate, refit and fully tighten the hex bolts (fig.1).
3.4.
Raise the transmission jack to support the suspension strut.
3.5.
Remove the support by reversing the above operations.
V
S3847 Issue 1 31/10/19
Original Language Version
© Jack Sealey limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing
fig.2
fig.1
