Carrier 50HX024, Product Data, Page: 22 / 28

Electrical data (cont)
50HX ELECTRIC HEATER PACKAGES — 208/240 V, SINGLE-PHASE,
SINGLE-POINT WIRING CONNECTIONS
UNIT
SIZE
50HX
ELECTRIC HEAT
ACCESSORY KIT
CPHEATER---A00
ELECTRIC HEAT
(kW)*
HEATER
FLA
MIN CIRCUIT
AMPACITY FOR
WIRE SIZING
MAX FUSE
OR HACR
BRKR
MOCP
208 V 240 V 208 V 240 V 208 V 240 V 208 V 240 V 208 V 240 V
024
001 3.75 5.0 18.1 20.8 42.1 45.6 50 50 — —
002 5.60 7.5 27.1 31.3 53.4 58.6 60 60 — —
015 7.50 10.0 36.1 41.7 64.7 71.6 — — 70 80
030
001 3.75 5.0 18.1 20.8 45.3 48.8 50 50 — —
014 5.60 7.5 27.1 31.3 56.6 61.8 60 — — 70
015 7.50 10.0 36.1 41.7 67.9 74.8 — — 70 80
016 11.30 15.0 54.1 62.0 90.4 100.3 — — 100 110
036
001 3.75 5.0 18.1 20.8 48.3 51.7 60 60 — —
014 5.60 7.5 27.1 31.3 59.5 64.8 60 — — 70
015 7.50 10.0 36.1 41.7 70.8 77.8 — — 80 80
016 11.30 15.0 54.3 62.0 93.3 103.2 — — 100 110
017 15.00 20.0 72.2 83.3 116.0 129.9 — — 125 150
042
001 3.75 5.0 18.1 20.8 52.1 55.5 60 60 — —
014 5.60 7.5 27.1 31.3 63.3 68.6 — — 70 80
015 7.50 10.0 36.1 41.7 74.6 81.6 — — 80 90
016 11.30 15.0 54.1 62.0 97.1 107.0 — — 100 110
017 15.00 20.0 72.2 83.3 119.8 133.7 — — 125 150
048
013 3.75 5.0 18.1 20.8 64.2 67.6 — — 80 80
014 5.60 7.5 27.1 31.3 75.4 80.7 — — 90 90
015 7.50 10.0 36.1 41.7 86.7 93.7 — — 100 100
016 11.30 15.0 54.1 62.0 109.2 119.1 — — 110 125
017 15.00 20.0 72.2 83.3 131.9 145.8 — — 150 150
060
013 3.75 5.0 18.1 20.8 72.0 75.5 — — 90 100
014 5.60 7.5 27.1 31.3 83.3 88.5 — — 100 100
015 7.50 10.0 36.1 41.7 94.6 101.5 — — 100 110
016 11.30 15.0 54.1 62.0 117.1 126.9 — — 125 150
017 15.00 20.0 72.2 83.3 139.6 153.5 — — 150 175
LEGEND
FLA — Full Load Amps
HACR BRKR — Heating, Air Conditioning and Refrigeration Circuit
Breaker
MOCP — Maximum Overcurrent Protection (fuses or HACR-
type circuit breaker)
NEC — National Electrical Code
*Electric heat capacity (kW) is based on heater voltages of 208 v or
240 v. If power distribution voltage to units varies from rated heater
voltage, see Wattage Multiplication Factors table on page 19.
NOTE: In compliance with NEC requirements for multimotor and com-
bination load equipment (refer to NEC Articles 430 and 440), the over-
current protective device for the unit shall be fuse or HACR breaker.
22