Ducted type
Move the unit in install the original state.
Make sure to install the electric insulation according to the relevant electric
standard in case the unit is installed on metal part of building.
Please keep away from the following places, or amalfunction may occur.
(if unavoidable, please consult a professional):
A. Near mineral oil like the oil for cutting machines.
B. Near an abundance of salty air. (near the coast)
C. Near caustic gases such as sulfuric gas. (Near a hotspring.)
D. In a factory where the voltage fluctuates greatly.
E. In a car or in a cabin.
F. In aS kitchen or a place full of oil steam.
G. Near a strong electromagnetic wave.
H. Near combustible gas or materials.
I . Near a evaporating acid or alkaline gas.
The ceiling is horizontal and it can handle the weight of the indoor unit.
The air inlet and outlet are not impeded and is not affected by outdoor air too much.
a
19.7in
/500mm
/100mm
3.9in
/1000mm
39.4in
/250mm
9.8in
/200mm
7.9in
/500mm
19.7in
/3m
9.8ft
18
Summary of Contents for 438MG series
