![background image](http://html1.mh-extra.com/html/carrier/40mhh/40mhh_owners-manual_2561986014.webp)
40MHH: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
14
Sleep Function
or
FRESH Function( ) (some units) :
AP Mode ( ) (some units) :
Follow me function ( ) :
SET Function
SET
SET
OK
Press SET to enter the function setting, then press SET or TEMP or TEMP
to select the desired function. The selected symbol flashes on the display area, press
OK
to confirm.
To cancel the selected function, just perform the same procedures as above.
Press
SET
to scroll through operation functions as follows:
Fresh ( ) Follow Me( ) AP mode( )
[ ]: If your remote controller has the
Fresh
function, you can not use the SET button to
select the
Fresh
function.
J
J
The
FOLLOW ME
function enables the remote control to measure the temperature at its current location
and sends this signal to the air conditioner under a every 3 minutes interval. When using
AUTO
,
COOL
or
HEAT
modes, measuring ambient temperature from the remote control (instead of from the indoor unit itself)
allows the air conditioner to optimize the temperature around you and ensure maximum comfort.
The
SLEEP
function is used to decrease energy while occupants sleep (and do not
require the same temperature settings for comfort). This function can only by
activated via the remote control.
Note:
The SLEEP function is not available in FAN or DRY mode.
When the FRESH function is initiated, the Ionizer/Plasma Dust Collector (depending on models)
is energized and helps to remove pollen and impurities from the air.
If the memory feature is stopped, “OF” displays for 3 seconds on the screen.
While the memory feature is activated, press
ON/OFF
, shift the mode or power failure will not cancel
the
FOLLOW ME
function.
NOTE:
Press and hold
Turbo
for seven seconds to start/stop the
Memory
feature of the
FOLLOW ME
function
If the memory feature is activated, “ON” displays for 3 seconds on the screen.
SLEEP Function
Press SLEEP
Choose AP mode to perform wireless network configuration. For some units, it does not work by pressing
the
SET
button. To enter the AP mode, continuously press the
LED
seven times in 10 seconds.