−
36
−
Power supply cord
Power cord connect cover
Earth line
Terminal block
Cord clamp
Screw
Screw
Screw
Fig. 8-4-17
(1) Open the air inlet grille upward.
(2) Remove the two screws securing the front panel.
(3) Before slightly open the lower part of the front panel,
pushing at specified bottom up until front take off
from installation plate. And then pull the upper part
of the front panel toward you to remove it from the
rear plate.
(4) After removing the front panel, remove the power
cord connect cover and the crod clamp.
(5) Connect and secure the power supply cord and
secure the cord clamp and the power cord
connect cover.
(6) Put the power supply cord through the notch.
(7) Be sure to smooth the notch with a file, etc.
For the air conditioner that does not nave power cord.
connect a power cord to it as mentioned below.
<How to connect the power cord>
8-4-
7
. Wiring Connection
3
1
2
Air inlet grille
Front panel
FILE NO. SVM-10036
Stripping length of the power supply cord
N
L
40 mm
10 mm
30 mm
10 mm
Fig. 8-4-18
Earth line
Taking out the power cord
Notch
CAUTION
For the air conditioner with the power supply cord
•
If the power supply cord is damaged, it must be
replaced bythe manufacturer, the service agency,
or another similarly qualified person in order to
Wire type : H07RN-F or more
Use stranded wire only.
NOTE
•
Put the power supply cord through the notch.
avoid hazard.
Summary of Contents for 38NQ009N
Page 63: ......