![background image](http://html.mh-extra.com/html/carrier/33cs400-01/33cs400-01_owners-manual_2563982046.webp)
Page 11.3
Viewing the Electric Heat Jumper Setting
Viewing the Electric Heat Jumper Setting
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
HUMIDITY
Press
ON
indicates that the
thermostat jumper is
set for Electric Heat
operation, or
OFF
for
Gas/Electric or Heat
Pump operation.
EH
I6
OFF
Setup
Placing the jumper on ELEC will cause the thermostat to turn on the
fan immediately any time there is a heat demand. Since most gas
furnaces control the fan, this feature should be off unless it is
necessary for the thermostat to energize the fan with first stage heat.
Step 16 is ‘Read Only’ and may only be set with the jumpers on the
circuit board of the thermostat.
Note: Press the
MODE
button momentarily
to move through the
setup screens. Press
and hold the
MODE
button to move back-
wards through the
setup screens.
11
HUMIDITY
MODE
MODE
Press the MODE button. While holding
the MODE, press the HUMIDITY button
to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Summary of Contents for 33CS400-01
Page 5: ......