4
Terminal Service Router - Release 1.3
Quick Start Guide
Installation
Installation
Installation of the router card into the Adit chassis.
l
Unit can be on or off
l
Router card will work in any slot
l
Slide card into slot until fully seated
l
Router has completed it’s boot cycle when CRD light is solid
The following setups are all executed with CLI
NOTE:
Configuration can be done with the following CLI commands or
with the Router Menu-Driven Software.
Basic Setup
Command
Description
set {ds0-addr} type data
Confirm DS0 is set to type data.
ds0-addr = {slot:port:channel} of DS0
Example: set a:1:1-24 type data
connect {slot:port:trunk}
{slot:port:channel}
Cross-connect T1 to router card.
Example: connect a:1:1-24 6:1:1 (router in slot 6)
set {router-addr} proxy
Disable/enable router proxy.
router-addr = {slot:port}| of router card.
Example: set 6:1 disable.
set {slot:port} up
Set Router LAN as In-Service.
Example: set 6:1 up
telnet {router_card-addr}
Telnet to Router card.
router_card-addr = {slot} location of router card
Example: telnet 6 (if earlier than 3.0 release {slot:port}
must be used)
Local and Remote Profile Setup
reinitialize
To enable any configuration changes, the card must be
reinitialized.
