5
1
2
3
4
5
6
7
3
4
11
Light on/off
ON / OFF
Road
Display functions
THTRIMM
Fine speed regulation
Here you can adjust the braking effect
on your vehicle.
The 2.4 GHz controller is suitable for
left- or right-handers and can be
adjusted as necessary by unscrewing
and refixing the steering unit accord-
ingly.
TRIMMsteering
Fine steering adjustment
If the vehicle does not run in a straight
line, you can make fine steering adjust-
ments here.
Function can be changed by
remounting the steering unit
To remount, unsrew the three screws on
the inside of the steering unit and screw
them to the opposite side.
Remove the cover plate from the other
side and mount the steering wheel to
the opposite side. Insert and tighten the
three inner screws again. Finished!
Stopwatch function
When the controls are switched ‘on’ -
the stopwatch appears. The stopwatch
can be started and stopped by pressing
the small wheel on the display. Press-
ing the disc for a prolonged period
resets the stopwatch to zero.
Stopwatch and LAP counter function
Please note:
The control unit in the LCD screen fea-
tures a LAP counter showing the pre-
programmed starting time. Currently
these functions are not in use and are
intended for future developments.
Display of the controller battery status
on the controller display.
THTRIMM
Fine speed regulation
Here you can adjust the braking effect
on your vehicle.
TRIMMsteering
Fine steering adjustment
If the vehicle does not run in a straight
line, you can make fine steering adjust-
ments here.
SP (TH trim) and AL (steering trim) are
achieved by repeatedly pressing the
small wheel.
Light on/off
Press the upper button on the controls
to switch the light on and off.
On / offroad mode
Press the middle button on the control
unit to activate the On/Offroad modes.
Can also be operated while the car is in
motion.
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
Troubleshooting
Problem
Solution
Car cannot be
controlled
Car does not move
The overheat protection has caused the car’s motor to cut out due to excess
temperature.
Either the switch on the controller or the car is set to OFF.
There is no rechargeable battery in the car or the battery is too weak.
The battery or rechargeable battery in the transmitter or model is too weak.
Vehicle starts moving unintentionally.
Switch off the receiver.
Leave the RC car to cool down for approx. 30 minutes.
Switch on.
Insert charged battery.
Insert new battery or recharged battery.
First turn on the transmitter, only then the vehicle.
Cause
