CARPENTER MODEL 93 COMPU-STRIP
Phone: 315-682-9176 Fax: 315-682-9160
Page
15
Revised 08/23/13 Website: www.carpentermfg.com E-mail: [email protected]
The Model 93 is now programmed to process your wire. You are now ready to run a sample wire and check for initial strip
quality. The following will assist you in processing your sample.
CARPENTER MODEL 93 COMPU-STRIP
PROGRAMMING
NORMAL MODE
cont
.
SINGLE CYCLE
Select
SINGLE CYCLE
key to produce one complete sample wire to check for accuracy. If corrections are necessary for
anything but overall length, then select the corresponding key on the Control Panel and make your adjustments. If length
corrections are necessary then proceed to
LENGTH CORRECTION
.
LENGTH CORRECTION
The Model 93 has a Length Correct feature that allows the operator to make adjustments from the preprogrammed length
versus the actual sample length. Small variations are normal due to differences in material, tension, friction, wire diameter
etc. If the sample wire was not the correct length select the
LENGTH CORRECT
key for adjustments.
LCD DISPLAY PROMPT
ACTION REQUIRED
PLEASE ENTER
Measure the length of the sample wire produced; enter this value for length.
MEASURED WIRE LENGTH
Press
ENTER
. The
Model 93 will automatically calculate the correction necessary.
The
0.00
next sample should be the
exact length you programmed.
The possible range of correction is +/- 10% of the overall wire length. If a value outside of this range is entered an error
message will appear and display the acceptable range of values.
The length correct value may be changed multiple times but typically a single entry is all that is required if the sample wire
was measured accurately and the data entered correctly.
RUN PROGRAM
After you have produced a satisfactory sample wire and all settings are correct press
RUN.
This will process your current
program.
STOP PROGRAM
If at any time you need to stop your processing press
STOP.
This action will stop the processing and wire feed.
UNLOADING WIRE
SINGLE
CYCLE
LENGTH
CORRECT
RUN
STOP
UNLOAD
WIRE
