caron 6105, Operation Manual

Page: 26 / 34

Model 6105 Operations ManualH Rev M 07-16-182/14/2021 Page 26 of 34
*Caron recommends using NIST traceable device to calibrate the controllers. A
Vaisala HMI41/HMP46 temperature/humidity detector or a similar device is
recommended. A “wick” type sensor is not recommended due to the likelihood that
the sensor will become saturated and give inaccurate readings.
MAINTENANCE
www.caronproducts.com
Electrical components (circuit breakers, fuses, relays, power supplies, etc.) are
located underneath the top/back panel. For additional service support, contact your
local distributor or CARON service department at
www.caronproducts.com . When
contacting CARON, please provide model number and serial number
Routine Maintenance
Routine chamber maintenance is necessary to keep the chamber working properly.
The recommended chamber maintenance schedule is:
a) Clean interior chamber (as needed)
b) If the humidity control portion of the chamber is going to be unused for 20
days, the small internal water reservoir should be drained. To drain the
internal reservoir:

turn the chamber on

set the humidity switch to off

set the temperature to 100ºC

open the back vent (remove stopper)

run for four hours

leave humidity switch off until humidity control is required
c) Check drains for blockage (monthly)
WARNING: Before removing top/back panel, disconnect all power!