DAMM
6
Rev. 02/17/12
STEP 4: PRE-TIGHTEN WRENCH
STEP 5: START TO MEASURE ANGLE
STEP 6: STOP AND WAIT FOR LCD FLASHING TO MEASURE ANGLE
•
Hold on your wrench to pre-tighten the screw.
(eliminate the backlash of wrench)
•
Press to start the angle meter and immediately
begin your angle torque measurement.
•
When measuring angle, if a long pause is detected
by the meter, then the LCD screen will begin to
flash, and it will hold the angle it recorded right
before the pause. You will need to press to clear
the screen and press to resume.
Note:
1. There are 6 LEDs to indicate the current angle
reaching 80%, 85%, 90%, 95%, 97.5% and 100%
of target angle.
2. There is also a buzzer to indicate reaching
level of target value. The interval sound means the
meter has reached 80% of the target angle. The
extended sound means you have surpassed 100%
of the set target angle.
Pre-tighten
Press
Press
100%
97.5% 95%
90%
85%
80%
((...((...
...))...))
over 80%
((((((((... ...))))))))
over 100%
Flashing
