Carlson Wireless USA revision 1.05 Page 8
INSTALLATION
Note that the installation of the FXO and FSO units are similar
(1) Connecting the feed cable to the outside unit.
On the mounting end of
the tube there is an end cap with a weather sealing clamp. This allows the
feed cable the penetrate the housing and remain sealed to outside weather.
Begin with the removal of the rear end cap by using a coin as a wedge and
working your way around the tube until the end cap pops off. Inside the end is
the electronics assembly consisting of the printed circuit boards and inte-
grated antenna. There are two screw down terminal blocks on the exposed
end. One block has 2 connections and it is where the DC power supply con-
nects. The other block has 4 connections, for telephone lines 1 and 2. The
following diagram shows how to wire the connectors. Make sure to hand
tighten only the weather sealing cord grip.
Note: Make sure that the antenna elements are vertical or perpen-
TIMESAVER TIP! By installing the FXO unit first,
you can test the sys-
tem locally by temporarily connecting the FXS unit up at the FXO site and
proving your connections. This can greatly simplify any trouble shooting you
may have later.
Carlson Wireless USA revision 1.05 Page 13
POWER REQUIREMENTS & CONSUMPTION
Filtered DC 12 to 48 volts
Absolute Maximum / Minimum 10 to 55 volts
Sub End, On-Hook 3 Watts max
Sub End, 2 Lines Off-Hook 6 Watts max
Base End - On or Off-Hook 3 Watts max
RF PERFORMANCE
Frequency Range 2400 to 2483.5 MHz
RF Channels 7+1 (admin)
Spreading Method Direct Sequence
Modulation BPSK
PN Bit Length 16
Processing Gain 12.04 dB
ERP (Effective Radiated Power) +28.5 dBm
Receive Sensitivity -93 dBm @10-6 BER
System Range 10 miles (16.1 km)
PHYSICAL & ENVIRONMENTAL SPECIFICATIONS
Enclosure Material ABS weather sealed plastic
Dimensions ( inches) 4 1/2 diameter x 30 in length
Dimensions (cm) 11 diameter x 76 in length
Shipping Weight (system complete) 24 lbs (11 kg)
Operating Temp -30 to +65 degrees C
Humidity 10 to 95% non-condensing
Shock and Vibration Mil standard 810 D
Exposure to the Elements Nema 4X, all except submerged
WARRANTY
2 years parts and labor - see detail
CERTIFICATIONS AND REGULATORY
FCC Reg No., Part 68 BMD USA – 27773-PT-E
FCC Reg No., Part 15 OPA-I-WLL, Pending Final
Industry Canada CS-03 3448-10241A
Industry Canada RSS-210 Pending Final
