CARLO GAVAZZI
INDEX
INSTRUMENT PANEL FEATURES
INSTRUMENT PANEL FEATURES
2
FUNCTIONS MENU
3
GETTING STARTED
4
Initial Set-up
4
AUTOTUNE
4
Tune or tune at setpoint program
5
PROPORTIONAL CYCLE-TIME
5
Cycle-time recommendations
5
SECOND AND THIRD SETPOINTS (SP2 and SP3)
5
Error messages
6
LINEAR INPUT
6
Set-up procedure
6
FUNCTION LIST
7
Level 1
7
Level 2
7
Level 3
8
Output Options Table
8
Re-transmission
8
Level 4
9
Level A
10
PROGRAMMER
11
Function overview
11
Getting started (Programmer)
12
Program run mode
12
Display functions
12
Example program
13
Function map
14
Function list
16
Memory allocation table
17
Memory full indicator
17
Programming example
18
Program edit example
18
MECHANICAL INSTALLATION
19
DIN panel cut-out
19
Mounting
19
Cleaning
19
ELECTRICAL INSTALLATION
19
Typical application
20
Input options (diagrams)
21
Output options (diagrams)
21
INPUT SENSOR SELECTION
22
Temperature sensors
22
Linear input
22
SPECIFICATION
22
SAFETY AND WARRANTY
23
2
Right Red LED:
Program Holdback
indicator
Orange Display:
Setpoint value or
program selection
Green LED:
Setpoint 1 output indicator
Upper Red LED:
Setpoint 2 output
indicator
Lower Red LED:
Setpoint 3 output
indicator
Green Display:
Process variable or
Function/Option
ADJUSTMENTS
To enter or exit
program mode
: Press
▲ ▼
together for 3 seconds
To scroll through
functions
: Press
▲
or
▼
To change
levels
or
options
: Press
✱ ▲
together or
✱ ▼
together
To view setpoint units:
Press
✱
To increase setpoint:
Press
✱ ▲
together
To decrease setpoint:
Press
✱ ▼
together
To reset latched alarm or tune fail:
Press
▲ ▼
together briefly
To run or Hold a program:
Press
✱ ▼
together for 3 seconds
Notes:
If in difficulty by becoming “lost” in program mode, press
▲
and
▼
together for 3
seconds to return to display mode, check the INSTRUMENT ADJUSTMENTS above and
try again.
When in program mode, after 60 seconds of key inactivity the display will revert to
either
inPt : nonE
or, if the initial configuration has been completed, the measured
value. Any settings already completed will be retained. During Program Configuration it
is recommended that this feature is inhibited. Select
ProG StAY
in Level 4.
This page can be photocopied and
used as a visual aid and bookmark when
working in other parts of the manual.
!
