PROPER USE OF YOUR CATERAIDE
1. Wash unit with hot water and a mild detergent, then rinse
thoroughly prior to use.
2. Pre-heating interior with hot water will improve heat retention.
Fill unit with boiling water and close. After 5 minutes, drain
unit completely through spigot and fill.
3. Pre-chilling unit with ice water in the same manner will improve
cold retention.
4. Load container to its maximum capacity with preheated or
prechilled beverage. Make sure gasket is in place. Replace lid
and lock into position by rotating a quarter turn clockwise until
it stops.
5. If you intend to use the security feature, you must make certain
the tag slot on the lid aligns with the tag slot on body (Refer to
picture to the right).
DISASSEMBLY
Drain unit completely before dismantling.
FAUCET AND SPIGOT
1. With spigot facing you, remove spigot by holding it in place while
turning front wing nut clockwise.
3. Remove exposed “C” ring by carefully pushing it out diagonally
from retaining groove. You can now remove the wing nut by
sliding it toward you off of the shank.
4. Next, remove the back wing hex nut from the shank by turning
counter clockwise. Also, remove the rubber rubber washer from
behind hex nut (Diagram 1).
5. Push shank backwards towards inside of unit to remove.
Remove rubber washer from large end of shank.
LID
1. Remove vent cap by unscrewing. Pull out washer from
underside of vent cap (Diagram 2).
2. Unscrew lid nut. Separate lid from plug assembly.
3. Remove gasket.
CLEANING THE CONTAINER
1. Clean after every use with hot water and a mild detergent.
De-staining compounds approved for food or beverage contact
may be used. Ask your detergent supplier for the proper
compound.
2. The body, lid, and plug are all dishwasher safe. When running
through a dishwasher, always make sure the gasket is
removed from the plug. Gaskets are NOT dishwasher safe.
3. Clean plug vent thoroughly with Carlisle Brush #40157.
I N S T R U C T I O N S F O R U S E A N D C A R E O F
C A T E R A I D E
™
X B B E V E R A G E S E R V E R S
P.O. Box 53006
Oklahoma City, Oklahoma 73152-3006
(405) 475-5600 • FAX (405) 475-5607
1-800-654-8210
#104803360
European Distribution Center:
Edisonstraat 84, P.O. Box 110
6900 AC Zevenaar, The Netherlands
Tel +31/(0)316-596550 • Telex 45642
FAX +31/(0)316-340168
DIAGRAM 1
DIAGRAM 2
BACK WING
HEX NUT
RUBBER
WASHER
FRONT WING
HEX NUT
"C" RING
VENT CAP
LID NUT
PLUG
GASKET
