BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
37570.0002A 08/11 ©2011 Bunn-O-Matic Corporation
ULTRA-1 & 2
INSTRUCTIONS FOR INSTALLING
LIQUID AUTOFILL KITS
INTRODUCTION
These instructions are for installing the Liquid Autofill Kits on Autofill ready ULTRA-1 and ULTRA-2 cold drink dispensers.
INSTRUCTIONS
1. Unplug machine from power source before removing any panels.
2. Drain both hoppers and clean the machine if needed before proceeding.
5. With a standard screwdriver and a
hammer, punch out the hole needed
for the level probe. Repeat this step
for all barrels.
4. Remove both motor covers and locate
.50" round knock out in top right area
of plastic drum mount. Discard screws.
3. Remove hoppers, drip tray, both side
panels and front panel.
(Continued)
KIT CONTENTS
ULT-2 ULT-1
A. 37567.0000
1*
-
Circuit Board, ULTRA 2 Auto-Fill
B. 37962.0001
1*
-
Wire Harness, AF Kit
C. 36329.0000
2
2
Tie, Cable-Nylon BLK 4.04"
D. 43120.xxxx
2
1
Cover Assy, Motor LAF-BLK
E. 38055.0003
2*
1
Probe Assy, LAF
F. 34362.0003
4*
2
Bushing .156" ID x .490" OD x .12" Flg
G. 00973.0000
4*
2
Nut, KEPS #6-32
H. 43131.0000
2
1
Bracket, Motor Cover Support
I. 43145.0000
2
1
Bracket, Motor Cover Mounting
J. 00970.0000
8
4
Nut, KEPS #8-32
K. 02308.0000
4
2
Screw, Pan Head, Slotted w/serr. #8-32 x .38"
L. 38129.0017
4
2
Hose, Braided .25 ID x 11.0" Lg
M. 21275.0006
8
4
Clamp .406/.504" Dia.
N. 01317.0000
4
2
Screw, Truss Head, Slotted #8-32 x .50"
O. 44194.0000
-
1
Wire Harness (Not Auto-fill Ready)
P. 44195.0000
-
1
Wire Harness (Auto-fill Ready)
* Not included in all kits.
