Carlisle BINKS MX44046 Series, Instruction Manual

Page: 12 / 16

Page 12 of 16 77-3290 R1.5
New Packings Only
Run Pump for 8 hours–then tighten the packings as per the adjustment procedure
Record Data
It is important to keep written details of
pump maintenance to allow service
intervals to be developed.
Pump
maintenance intervals are
dependent on pump duty, pump
pressures, cycle rates and material
abrasiveness.
Adjustment Procedure
1. Turn off pump
2. Isolate & Depressurise Fluid
Section
3. Clean out Lubricant Cup if high
level of material contamination
is found
4. Undo packing nut by half a
turn (180°) to relieve pressure
on O-ring seal
5. Tighten packing nut to 120Nm
using tool 502893 and suitable
torque wrench
6. Refill Lubricant Cup with
approved Lubricant
7. Open isolation valves and
restart pump
8. Record Data i.e. date / amount
of adjustment made
Packing Seal Lubricant
Ensure the Lubricant Cup is always at least 1/3 full with compatible seal lubricant
(0114-016099 Water Based) (0114-016100 Solvent Based)
Daily – Check the Pump to ensure that
there is sufficient lubricant in the
lubricant cup and that there is no
material contamination.
Weekly – Retighten packing nut, if
required, following the adjustment
procedure – Record Data
MX440CL-SMH
INSPECTION & MAINTENANCE GUIDANCE