Vita II
Loading media
11.18
Operating manual
29
J
I
K
M
L
H
E
F
G
D C
A
B
Figure 9
1. Open the printer cover.
2. Open printhead (G) by turning the red pressure lever (F)
anticlockwise.
3. Remove the outside label mounting plate (A).
4. Load the label roll with inner winding onto the unwinding roll (B).
5. Attach again the label mounting plate (A).
6. Lead the label material below the return pulley (C) and printhead
(G) and hold it towards the marked stopper surface (N).
N
Pay attention that the label runs through the photocell (E).
7. In order to move the printhead (G) down, turn the red pressure
lever (F) in clockwise direction until it locks.
8. Adjust the adjusting ring (D) of the return pulley (C) to the width of
material.
Loading label in
dispenser mode