Carl Valentin Spectra series, Service Instructions Manual

Page: 43 / 78

Spectra series Refitting options
1108 Service instructions 43
6 Refitting options
DANGER!
Risk of death via electric shock!
⇒
Before opening the housing cover, disconnect the
device from the mains supply and wait approx. 2 - 3
minutes until the power supply unit has discharged.
6.1 Memory card slot
Figure 26
1. Remove left printer cover.
Loosen 3 screws (A) at the lower
left printer edge and 3 screws (B)
at the chassis upper edge.
2. Remove the protective conductor at
the inside of the printer cover.
3. Remove the cover at the breakout
(C). The breakout is behind the
CPU at height of Centronics
interface.
4. At the print mechanics side,
remove both of the label unwinding
disks.
5. Fix 4 enclosed distance bolts (G)
with the corresponding washers
and nuts (F) at the memory card
plate.
6. Insert connecting cable (D) onto
memory card plate.
7. Place the pre-assembled memory
Card plate (E) behind CPU and fix
it with the enclosed countersink
screw at the chassis base.
8. Insert the connecting cable (D)
corresponding to the wiring plan
(see chapter 8, page 59), into the
appropriate plug-in position ST20
of the CPU.
9. Connect the protective conductor to
the inside of cover.
10. Mount again the printer cover and
label unwinding disks.