8
the centerline of the servo. Cut the servo arm so it does not
touch the fuselage side, approximately 7/16" [11.1mm] from
the center of the arm. Remove the unused arms and reinstall
the servo arm. Reinstall the servo arm screw. With the rudder
centered and rudder aligned with the fi n, mark the pushrod
wire at the servo arm.
10. Bend the wire up at the mark. Cut the wire 5/16" [7.9mm]
above the bend. Secure the pushrod to the servo arm with
a nylon FasLink
™
. Make sure the FasLink does not hit the
fuselage side or bind against the servo arm.
11. Slide the two plywood outer pushrod tube supports
over the elevator outer pushrod tube.
12. Center the elevator servo. Trim a servo arm to fi t
perpendicular to the elevator servo. Remove the other unused
servo arms.
13. Install a quick connector on the elevator servo arm
following the same procedure used to install it on the elevator
control horn.
14. Install the servo arm on the elevator servo. Route the
elevator cable through the quick connector on the elevator
control horn and the elevator servo arm. Apply a drop of
threadlocker on a 3 x 5mm machine screw. Install the machine
screw in the quick connector on the elevator control horn and
tighten it against the elevator cable.
15. Use CA to glue the two plywood elevator outer tube
supports in the slots in the fuselage side.
Summary of Contents for Sophisticated Lady GPMA1959
Page 20: ...19 ...
