16
Wild Stick .40
8. Install the elevator servo, throt-
tle servo and switch in the cutouts
provided in the servo tray.
9. use a long 3/16” drill and drill a
hole in the firewall in line with the
throttle are.
10. Bend a 90 degree angle in the end
of the throttle pushrod and cut at
3/8”. Attach to the throttle arm and
retain with a nylon swing in keeper.
11. locate the pushrod connector
and attach it to a servo arm. It has a
washer on top of the arm, the bottom
of the arm, then install nut. Use a
drop of CA glue on nut to make sure
it does not come loose. Make sure the
pushrod connector will rotate in the
servo arm.
