211083
8
Vedpak 104GB_Version 2_040909
GB
TO ACTIvATe COMPONeNTs WITH
POsITIve (+) vOlTAge
Contact the probe tip to the positive terminal of
the component, the LED indicator should light
GREEN.
While keeping an eye on the green indicator,
quickly depress and release the power switch
forward (+). If the green indicator changed
instantly from GREEN to RED you may proceed
with further activation. If the green indicator went
off at that instant or if the circuit breaker tripped,
the tester has been overloaded. This could
happen for the following reasons:
• The contact is a direct ground.
• The component is short-circuited.
• The component is a high current component
(i.e., starter motor).
If the circuit breaker tripped, reset it by
depressing the reset button.
WARNINg: Haphazardly applying voltage to
certain circuits can cause damage to a vehicle’s
electronic components. Therefore, it is strongly
advised to use the correct schematic and
diagnosing procedure while testing.
Trick: When powering-up compo-
nents, you can increase the life
of your tester switch if you first
press the switch, then contact the
tip to the component. The arcing
will take place at the tip instead
of the contacts of the switch.
