Carel PlantVisorPRO, Technical Leaflet

Page: 7 / 13

PlantVisorPRO Embedded
Cod. +050000625 - Rel. 1.1 26/06/07 12
2. Installation
The system is supplied with a black and white cable that must be connected to position (8). This cable should then be
connected to a mouse and a keyboard, the mouse to the black end and the keyboard to the white end. Once the mouse and
the keyboard have been connected, plug the monitor into connector (7). Then plug the power cable into connector (1) and
the 220 Vac power supply. Finally, connect the CAREL 485 network. The connector used depends on the type of converter
selected. The system is supplied together with the CAREL PC-GATE converter. To use this converter, connect the serial cable
to the COM2 port, that is, connector (2). To use the 485 USB converter (CVSTDUMOR0), any of the USB ports can be used,
connector (5). Optional: if the PlantVisorPRO Embedded needs to be connected to an Ethernet network, plug the network
cable into connector (6). Connector (3) can be used to interface to a parallel printer.
2.1 Setup
Once the cables have been connected (see the previous paragraph), switch the system on using button (1). At the end of
start-up phase, the following screen is displayed, prompting the user to select the language the screens will be displayed in.
Once having made the selection, click “OK”.
Fig. 2.1
Then the user license must be accepted; click “Next >”.
Fig. 2.2