Carel DP, User Manual

Page: 69 / 76

33
ENG
DP S030220660 rel. 2.3 - 06.12.2021
For the electrical connections, remove the top cover of the sensor. For the configuration, see the instructions shown below.
Duct version
The duct version is connected to the air duct using the special fastening bracket.
61
120°
120°
25
42
98
105
PG9
CH19
n°3 holes Ø 2,75 (da non filettare)
Ø 17
37,5
43,3
= =
Fig. 4.t
Assembly notes
• Fasten the bracket to the air duct;
• Insert the rod on the bracket to the required depth;
• Tighten the screw on the bracket to fasten it
For the electrical connections, remove the top cover of the sensor. For the configuration, see the instructions shown below.
4.13 C hanging the default configuration for the wall sensor and duct
sensor
To change the default configuration:
1. Remove the cover by rotating it anticlockwise;
2. Remove the two screws and remove the protective cover;
3. Change the selection pin, according to the required configuration;
4. Place the protective cover and fully tighten the two screws;
5. Close the cover again by rotating it clockwise.
Fig. 4.u
4.14 Version with N T C output only
The temperature-only version with NTC resistive output uses an NTC sensor 10K@25°C (beta 3435), see the temperature-resist-
ance table shown below, with the following characteristics of the terminal:
Rated cross-section 2.5mm2
Maximum screwdriver size 2.8 mm
Terminal plastic material Polyamide PA6
Terminal Chrome-plated brass
Terminal screw Chrome-plated steel
Tab. 4.r